The rubber is first sliced by a rubber mixing machine, and then sent to a sol tank to mix with gasoline for sol. After the sol is emulsified and prepared, it is pumped to the latex intermediate tank. The rubber solution dissolved in gasoline is fed from the top of the distillation tower, and is heated and distilled by steam. The light component gasoline is heated into a gas phase, and the gasoline gas is mixed and cooled by cold water in the oil-air cooler. The oil-water mixture then goes to the oil-water separator, the oil-water layer. The upper layer of gasoline is recovered, and the lower water is pumped to the cooling water tower for cooling. After cooling, the gas gasoline in the distillation tower is cooled; the latex of the distillation tower is sent to the latex mixing cylinder to stir according to its own pressure, and then it is adjusted to the centrifuge to separate the glove material latex. Set aside after toning and filtering.

The glove model is first cleaned with acid and alkali and washed with water. The washed model is first immersed in hot water and heated until it is soaked in coagulant and dried for dipping. After dipping, it is sent to an oven for preliminary drying, adding fiber inner sleeve, flushing hot water and then sending to the oven for vulcanization, drying and forming. After the gloves are demolded, they are inflated, checked, shaped at low temperature, dried at medium temperature, washed with water, dehydrated, dried, and then packaged and sent to the finished product warehouse.